Question:  How can I install a spindle on my CNC?

Question:  Which control software should I use, Mach 3 or UCCNC?

Question:  How can I change my screenset in Mach 3?

Question:  Should I program using Conventional of Climb cuts?

Question:  How do you install a touch off plate with Mach 3?

​Question:  How do I use a Triple Edge Finder with my CNC?

Question:  How do you install a touch off plate with UCCNC?

The picture above represents the different results you can get when running a CNC program.  The "Laser Test" in the upper left is when you machine settings are set correctly.  The "Laser Test" in the upper right shows the results you get when you X-axis is set incorrectly.  The "Laser Test" in the lower left shows the results when you Y-axis (or Y and A axis if slaved) is set incorrectly.  And finally the "Laser Test" in the lower right shows the results you get if your X and Y axis are set incorrectly.

​Question:  How do I tram my Router/Spindle?

Vectric Tutorials on Rotary Axis

Question:  I'm running a V-Carve program and I'm not getting clean cuts.  What could cause this?

Question:  Can you explain how to change a tool with Mach 3?

Copyright © David Gatton. All rights reserved.

Question:  How can I put a Keyhole slot in my work?​